Roof Edge Flashing for your Roofing
Roof edge flashing ridges include a safety welt on the edge to increase the strength of the material and come as a 3m length as standard. When fitting the ridge please remember to allow a minimum of 200mm overlap from one ridge piece to the next. Ridge pieces sit on top of the roofing sheets and are stitched (using ST22 Stitching Screws) to the sheet below to secure them in place.
Used at the apex join of two sides of the roof, ridge flashings are a necessary part of any profiled clad building and with the range and colours that are available, can enhance the aesthetics of any structure.
Our ridges include a safety welt to increase the strength of the material.
It is advised that these Flashings are only installed alongside our 41/1000 Tile Form Roofing Sheets.
Please note: The 200 x 200 flashings give a coverage of 192 x 192 due to the 8mm welt.
Please note: Copper Brown is only available in our GreenCoat® Mica BT coated steel in 0.6mm thickness. This finish will be upgraded to the new GreenCoat® Pural BT coated steel in 0.7mm thickness in due course.
