About Our Barge Board Flashings
Manufactured as a 3m length and refolded to a 90-degree internal angle, the barge board flashings for corrugated roofs will flex 10 – 15 degrees either way, dependent on your needs. Cladco folded steel flashings come with a safety welt to increase the strength of the material. Used at the end of a run of sheets to trim and seal off the edge of the roof, at Cladco Profiles we aim to accommodate wherever possible. For custom flashings simply give us the dimensions or drawing of the trim you need to be folded and we will do our best to accommodate you.
Our flashings come with a safety welt to increase the strength of the material. Stock flashings for corrugated roofs have a 90-degree angle and measure 200mm x 200mm with a 3m length. Flashings are a necessary part of any profiled clad building and with the range and colours that are available can enhance the aesthetics of any structure.
These Flashings are only recommended for use with our 13/3 Corrugated, 32/1000 Box Profile and 34/1000 Box Profile Roofing Sheets.
Please note: The 200 x 200 flashings give a coverage of 192 x 192 due to the 8mm welt.
Please note: All Juniper Green polyester sheets and flashings may exhibit slight colour variances between products. If you are looking to match to a previous or existing order, please call us on 01837 659901.
Our Flashings coated in Polyester Paint are sent with a clear protective film. To prevent it from adhering to the coating, peel the film off after installation or when exposed to direct sunlight or rain while in storage.
